WINKING  EPOXY  ADHESION  SYSTEM

WK-1402
GENERAL DESCRIPTION：
This is an one component, hot curing system, rigid epoxy adhesive and insulation for blob top.It is sutitable for the high quality electrial industry. The material can be mix with solvent to lower the viscosity.
 
STORAGE  INSTRUCTIONS
  Refrigeration of uncured compound is required to maintain viscosity.
If Slight separation occurs.Stir gently until product is uniform , after
allowing unopened container to reach room temperature.

PROPERTIES OF UNCURED MATERIAL:     ( @ 25℃ )
1.Appearance:        Any color dense liquid
2.Density:               1.5
3.Shelf life:            @25℃/3 Months  @40℃/14 days
                              @ 5℃/6 Months
5.Gel Time:            100℃/20 min ; 120℃/10min
6.Curing Time:          100℃/ 2 Hrs  ;  130℃/1 Hrs

PROPERTIES OF CURED :   ( Curing Condition: 120℃ / 2 Hrs. )
Hardness                                                      Shore    D     91    ASTM  D  2240   
H. D .T                                                             ℃           155    ASTM  D   648
Moisture absorption                          @ 100℃ / 1 Hrs  0. 25   ASTM  D   570  
Glass transition                                                 ℃           140    ASTM  D   256
Thermal shock (no cracking)               10 cycles  -55 to 130℃  ASTM  D  1674
Dielectric constant                                 @25℃,1KHz   4.3      ASTM  D  150
Cofficient of linear                                  cm / ℃      4.6X10-5   ASTM  D  1674
thermal expansion           
Thermal conductivity                        cal / cm.sec℃  7.6X10-4  ASTM  D  1674
Linear shrinkage                                                   %          0.2     ASTM  D  2566

NOTE:
* Keep in cool low temperature ( @ 5℃ or below ) avoid moisture and
sun shine directly, to keep long using.
* Avoid contact of the skin, eyes and clothes, in case of contact, just wash
with soap and water immediately.